tile adhesiveWebertai 2 in 1

High-quality, single-component waterproof tile adhesive. Easy to use, just mix with water. Contains cement, specially selected sand, and special chemicals. Strong adhesion, increases waterproofing properties for tiling in bathrooms, kitchens, and areas exposed to water.

Suitable for: Ceramic tiles, granite, marble, granite, artificial stone, size up to 1x1 meter.

Size: 5 kg. per bag / 20 kg. per bag

color: grey

Usage volume: 

• On average, 1 sq m per 5 kg bag.
• Average 4 sq m per 20 kg bag.

How to use

Surface preparation:

• For new surfaces: The surface must be smooth, hard, level, clean, dry and have normal water absorption.
• For existing surfaces: Check the surface by scraping off any loose paint or removing loose tiles and laying new ones. Remove any debris such as cement powder, fat, or oil stains stuck to the surface.
• If the surface is very porous (high water absorption), it is necessary to wet and saturate the surface with water before laying the tiles.
• If the surface is a plastered wall or newly leveled cement: the curing time should be in accordance with the standard.
  (7 days per 1 cm. thickness) before laying tiles

Mixing

Mix Weberline 2-in-1 cement glue with water at a ratio of 1 : 3 by volume.
(1 part water, 3 parts cement glue) Use a blender at low speed to blend until smooth, or divide and mix a little at a time and stir thoroughly until the glue does not clump. Leave for 3-4 minutes before use.

Tiling

1. Use a notched trowel to spread the cement glue onto the surface.
2. Spread a thin layer of cement glue over the back of the tile to ensure waterproofing properties.
3. Lay the tiles on the cement glue and use a rubber hammer to knock them all over.
4. Wipe away any excess cement glue that has spilled out of the grout lines and that has stained the surface of the tiles.
5. Customize your tiles in 15 minutes
6. Leave for 24 hours before grouting.

Shelf life and storage

1 year from the date of manufacture, if the bag is unopened and stored in a shady, dry, non-humid place with good ventilation (if the bag is not completely used, the bag must be tightly sealed).

note : These test results are obtained from sample laboratories and may differ from the results obtained fromMixing at different agencies due to different usage methods and agency conditions.